[C.CC USERS] Finally, occam-pi runs

[Dennis Meade]

Thanks to Adam, Christian ,Matt and Omer, my Arduino is now running 
occam-pi code.

I'm building an Arduino controlled robot. At this point, I have occam-pi 
code running which tests control of the motors. Next step is getting the 
servos which control the pan'n'tilt to run in parallel. Not to speak of 
learning occam-pi.

I was aware of the autoconf version problem. During the first setup of 
Ubuntu, the version the version was ok at 2.59, but when I went back and 
started over from scratch I had a problem getiing rid of 2.64. My Linux 
experience is pretty shallow. I could run autoconf with the name 
autoconf2.59, but that apparently caused me more problems. At any rate 
when  I started over, I should have switched to Ubuntu 10.04 as Omer 
suggested.

Regards,

Dennis

-- 
Dennis