[C.CC USERS] Qs re occPlug's "Arduino" target and "Upload Firmware". *apologies; newb*

[Michael M. Butler]

Would it be of use for me to try to do an AVRdude dump of the flash a
la Matt's comments from around Jan 7th and mail that over to you?

On Mon, Jan 24, 2011 at 6:25 AM, Michael M. Butler <mmbutler at gmail.com> wrote:
> The only other thing I can thing of is that this board uses a
> resonator rather than a crystal. Could a 0.5% timing variation mess
> things up for the occam code loading but not for the firmware upload?
> I'm grasping at straws here. (grin/grimace)
>
> On Mon, Jan 24, 2011 at 5:12 AM, Michael M. Butler <mmbutler at gmail.com> wrote:
>> After trying heartbeat and the Chapter 2 blink code, I've tried
>> adapting and twiddling Steve Pretty's serial.write test code to see if
>> there's a Pin13 pin-mapping problem that doesn't affect TX0, but so
>> far I'm not seeing output from that.
>>
>> So based on my experiences I'm left wondering. Does occPlug's
>> Device:Arduino target setting work with a 16MHz ATMega328?
>>
>> Is it possible the Firmware load worked properly, but that the occam
>> .ihex files are being transmitted at the wrong baud rate for this
>> platform?
>>
>> M
>
>
> --
> Michael M. Butler  = =  m m b u t l e r  at  g m a i l . c o m
>



-- 
Michael M. Butler  = =  m m b u t l e r  at  g m a i l . c o m
. . . Just remember, immanentizin' the eschaton is
. . . . a dern sight easier than /monetizin'/ it. --me