Hello,<div><br></div><div>I've recently started tinkering with an Arduino (I've only been using it for a few weeks), and came across Plumbing as a way to parallel program using the Arduino. I've been following the tutorial provided on the Concurrency website (Plumbing for the Arduino), but ran into a technical issue and was hoping that I might be able to get some help. </div>
<div><br></div><div>In Section 1.3, the guide instructs me to install the Transterpreter firmware on the Arduino. I downloaded the file from Concurrency and opened Transterpreter. When I go to the "Plugins" menu, "occPlug", and select "Upload Firmware...", Transterpreter crashes. I tried unplugging the Arduino from my computer, and I can make it as far as the menu in Figure 1.6, but then when I plug the Arduino back in and attempt to select a Port, it crashes again. </div>
<div><br></div><div>Any suggestions or guidance you might be able to offer would be greatly appreciated! Thank you!</div><div><br></div><div>Michael</div><div><br></div><div>PS - And I'm doing this on a Mac. </div>